View Single Post
  #9  
Old 02-11-2019, 04:26 AM
Glaurung's Avatar
Glaurung Glaurung is offline
vBench
 
Join Date: Nov 2005
Location: Tallinn, Estonia
Posts: 163
Shortly after the last update I posted here, I studied the photo further and discovered that the co-driver's hatch on my model is on the different position than showed on the photo. Looking the photo it appears to be on the same line to the driver's hatch, while on the model it is located slightly backwards. There was a slight inner dilemma, whether I should address this problem, or ignore it, but I felt brave and after a considerable amount of exacto-blade terror on the part, I relocated the hatch to the correct position. After that there were a lot of filling and sanding and then restoring the bolt heads and weld beads that were destroyed during the process.

On the photos the cut seems to be empty, but it is actually transparent super glue and there's no gap there.







Reply With Quote top
Users like Glaurung's post!