View Single Post
  #17  
Old 12-22-2010, 12:43 PM
Fledermaus's Avatar
Fledermaus Fledermaus is offline
Senior Member
 
Join Date: May 2007
Location: Puerto Rico
Posts: 381
Hi to all Again!
Work continues with the 3.7 flak, after removing all the molded details this are replaced with Eduard’s PH parts giving it a nice detail change..
With the details removed


And with the new PH details


Next the Master barrel, Excellent!


Then I moved to the shield assembly, after bending and soldering it in the corners, it was glued to the base



The PH shield hinges with styrene rod pins

I removed the shield locks from the original shield to be used in the PH one as the ones included it the Eduard set are flat, in this case the originals are better…
Using a chisel blade to carefully remove the details

Here the hinges and locks are glued in place

And the interior locks

A few missing detail added from the part box, the PH pedal is glued in place and a wire rod
__________________
"Don't be afraid of the model,it's you the one holding the knife"

Last edited by Fledermaus; 07-28-2017 at 01:10 PM.
Reply With Quote top
Users like Fledermaus's post!